Built with Volusion
Visit our location!
150 Riberia Street
St. Augustine, FL 32085
Phone: (904) 829-2271

Check us out on
Facebook!

  Home > Pumps and Parts > Rule Pumps >

Rule Pumps Automatic 12 Volt DC Bilge Pump, 500 GPH 25S (D)

Rule Pumps Automatic 12 Volt DC Bilge Pump, 500 GPH 25S (D)
 


Product Code: 2001030000025S
Qty:

Description
 

Rule Pumps 25S, Fully Automatic 500 GPH submersible 12 volt DC bilge pump is used by leading boat builders worldwide. It features an easy clean snap lock strainer, silent and vibrationless operation, anti-airlock protection, compact, efficient long life motor, marine grade blocked wiring, ignition protection, no burn-out when run dry and rust and corrosion protection.

Specifications
Automatic Operation: Pump turns on and checks for water approximately every 2-1/2 minutes. If resistance (water) is found, it will run for as long as water is present. When all the water is pumped out, the pump shuts off and returns to its 2-1/2 minute test cycle. Amp Draw During Automatic Check: 0.5 Amps in a 24 hour period Manual Operation: The pump can be started at any time by disconnecting it from the power source, waiting for 5 seconds and reconnecting to the power source Amp Draw @ 12.0 Volts: 1.9 Amp Draw @ 13.6 Volts: 2.5 Fuse Size: 2.5 amps Discharge Opening: 3/4" Discharge Finish: Barbed Housing Material: ABS Strainer Material: ABS Impeller Material: Nylon Shaft Material: Stainless Seal Material: Nitril/Teflon Temperature Limit: 200 F Fluid Capabilities: Bilge Water Typical Life: 1500 hours Wire Length: 29" Wire Gauge: 16 gauge Height: 3-1/2" Width: 2-3/8" Depth: 2-3/8" Weight: 9 oz Certifications: NMMA Type Accepted Equipment # 704213, IMCI Certified - ISO 8849, CE Certified.
Capacity # 25S Automatic Pump In Gallons Per Hour
Operating Voltage Head In Feet
0' 3.35' 6.7'
Gallons Per Hour
12 VDC 480 310 180
13.6 VDC 500 360 260

Share your knowledge of this product. Be the first to write a review »